solid 4.8 or 5.3 vortec

[wa2fastcamaro]

you can get these motors for about $600-$800 at 7th ave depending on mileage. They usually got a few on hand all the time. But I think thats going to be your best bet.

[beachbum_jon]

what about a 6.0 lq4?

[zbrown]

beachbum_jon;211822 wrote:
what about a 6.0 lq4?

do they have the same block dimmensions?

wa2fastcamaro;211819 wrote:
you can get these motors for about $600-$800 at 7th ave depending on mileage. They usually got a few on hand all the time. But I think thats going to be your best bet.

thanks

[weshole]

zbrown;211811 wrote:
anyone have a solid 4.8 or 5.3 vortec engine lying around they want to sell?? or know where to find a cheaper and available one??

I may have see the light

thanks
zac

SAY IT ISN'T SO?!?!?! NO MORE ROTARY?

[Parker]

smart boy.... but ill always be one step ahead...

[zbrown]

Parker;211831 wrote:
smart boy.... but ill always be one step ahead...

godman talk on chat will ya

[Parker]

fine then

[beachbum_jon]

yep

[KA-T_240]

how bout a cummins?

[Cura86]

Check Roadside Salvage north of fergus. Last time I checked they had a low mile 5.3 for $600.

[beachbum_jon]

KA-T_240;211856 wrote:
how bout a cummins?

yeah, i 5.9 might be a little big for a rx7, but a 3.9 certainly wouldnt be. that wold be a sweet swap, and pretty unique?

[zbrown]

beachbum_jon;211941 wrote:
yeah, i 5.9 might be a little big for a rx7, but a 3.9 certainly wouldnt be. that wold be a sweet swap, and pretty unique?

lol, a little nose heavy and those blocks are so tall it would come to roof level

[Parker]

your not cool unless you have SBF

[MisterCMK]

Parker;211960 wrote:
your not cool unless you have SBF

O RLY?

[MisterCMK]

Silly triangleamabobs

[Parker]

Parker;211960 wrote:
your not cool unless you have SBF
oh WTF.....your not abusing your mod powers.... ass

[94NDTA]

What would you use as a tranny?

[Christian]

I just bought a 5.3 complete and a 6.0l (which is going in my mustang project) on friday if you need a 6.0l core to rebuild I have one had minor piston slap. I believe around 60 k on the motor or you could just use it as is cause they all have piston slap.

[94NDTA]

Did you get a harness and computer for it? How much did you pay? Where did you get them?

[Christian]

6.0 l was just a long block 5.3l was complete with harness minus computer. Picked them up from a private guy in Valley City. The core 6.0l (which i think u can just put in and run as is) I would like to see 400.00 out of it.