My POS engine build pictures.
-
7MGTE FTW!
Some minor details, ROSS forged pistons with teflon coatings, and Eagle rods. All zero balanced.
-
aint shit unless its a 1.8t!
-
zbrown;290377 wrote:
Is a 2jz a 2 bolt bottom end too?If I remember correctly yes it is. But we also have 7 mains.
-
zbrown;290382 wrote:
I realize that, just curiouswhy no ARP hardware on the mains? not needed?
I don't think its 100% necessary, however My main goal was to assemble it with plastigauge to check specs before spending anymore money.
So far so good
-
If engine parts were free I would have sent 3.2 stroker and high compression.
-
zbrown;290387 wrote:
why you cant run high compression on boost....Sure you can.
A little more finicky of a tune but it is very doable.
-
zbrown;290391 wrote:
ha you missed my sarcasm towards the people who dont think you can, I am a big HC boost guymy engine is 10.3 static
That should prove to be very very fun.
-
-
-
Made myself a fuel rail. -10 straight threads on both ends, will be using a single feed.
-
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login