Th-400 ??

[XJHEAD]

Anyone know what the total length on a TH-400 torque convertor is??

[Bookem]

I'm assuming you mean front to back, I can measure one after I get outta work here in a few hours.

[XJHEAD]

Please do, pads to the very front

[Bookem]

XJHEAD wrote:
Please do, pads to the very front

6'' even

[DaveH]

My converter measures just slightly less than 6".

[Bookem]

DaveH wrote:
My converter measures just slightly less than 6".

I measured off a brand new one if that makes a difference.........maybe

[XJHEAD]

They should all be the same I thought, mine measured 5.8125 way too short. Dave did you run washers between flex and t/c??? How much if any?? Was told by JW 6.15-6.2

[DaveH]

My converter came with 1/4" spacer pads tack welded onto the converter. It's hard to measure the exact thickness, just using a tape measure it appears mine is just under 6" including those pads.

[XJHEAD]

Can you guys also check the difference between the pads to the end of the t/c crank pilot.. past pads or short of pads...

[Bookem]

DaveH wrote:
My converter came with 1/4" spacer pads tack welded onto the converter. It's hard to measure the exact thickness, just using a tape measure it appears mine is just under 6" including those pads.

The one I measured off of was designed for a dirt track late model maybe they have lil bit thicker pads and that would account for the diffreence.

[Bookem]

XJHEAD wrote:
Can you guys also check the difference between the pads to the end of the t/c crank pilot.. past pads or short of pads...

I'll see if I can find a stock one at the shop to measure off instead of an aftermarket to make sure I don't give you inaccurate numbers.