Got a new toy today. :)

[PSiedTSi]

hope you dont break anythin...

[out there]

exedy twin-plate? does that have some sort of special disc you have to use with it?
what flywheel?

[Sweet-WRX-Lovin]

92BlackTT wrote:
I was expecting some sort cheeseburger producing belt buckle....
...nice clutch tho

LMAO @ 92BlackTT

[integra_gsr98]

It uses exedy's discs for their twin plate clutch.

It's just setup like a motorcycle clutch now. Friction and Pressure Plates sandwiched together in a clutch basket.

[2wheeler]

Really, cause my bike only has 1 pressure plate and sandwiches drive plates and driven plates(fibers and steels) together. Is it a wet clutch now like motorcycles or is it still dry like gay Ducatis?

[integra_gsr98]

Sorry bout that. I didn't know the proper "names" for the different plates.
It does only have a single "pressure plate" on the outside.

Also the clutch remains dry.

[91nbtsi]

Looks expensive! Now when you going to get the release bearing set-up?

[integra_gsr98]

The exedy doesn't use the release bearing setup that the Tilton does. So I will just be using a stock TOB.

I mainly went w/ the exedy after reading about replacement parts if anything does fail with it. Quite a bit cheaper for this one to break, if it does break, than a tilton.

[91nbtsi]

Well then, that is good! Get it in your car. What else do you have left to get? Manifold done? etc.

[integra_gsr98]

It's close. Will make it's low boost and pump gas debut with the new setup on the opening weekend.

Should run the times it did last year on race gas on pump gas and 18 psi this yea rif it all works out.