Harwood's Civic Project

[harwood39]

Ok. So i have most of the motor assembled, i need to put the oil pan on and do the valve lash. Here are some pics of how it looks so far. I also need to redo the ITB's, they kinda point directly tawards the firewall, not at an upward angle like they should. I will keep everyone updated as the build progresses.

PICS:

[harwood39]

Pics Are Up

[SleeperMx6]

What pistons did you get? what rods? how long befor it runs? how long befor it falls apart.. lol jk

Good work

[harwood39]

Who knows when it will be actually done...still need some parts...i used p29 pistons, stock rods, ARP Rod bolts, ARP head studs, ACL Bearings, OEM Honda oil pump, water pump, ACT Fly wheel, Exedy stage 2 clutch, greddy catch can...

[DelSlow]

looks good Ho Ho

[harwood39]

does any one know if honda made a single belt crank pulley for this motor? i know they make 2 belt ones, but i only need one to run the alternator and if i could do away with an extra grove or 2 on the pulley that would be great.

[GraveDigger]

Did you get a new motor, or just rebuild the same one? Goin from 130hp to 150, nice.

[harwood39]

its the same d16z6...and it should be putting out more than 150...the ITB's alone on a stock motor tuned with a VAFC braught a d16z6 up to 157WHP

[GraveDigger]

This post is deleted!

[SleeperMx6]

This post is deleted!

[Jim]

This post is deleted!

[LT1]

This post is deleted!

[Bryce]

This post is deleted!

[GraveDigger]

This post is deleted!

[aliengotpsi]

This post is deleted!

[AcesHigh]

This post is deleted!

[GraveDigger]

This post is deleted!

[integra_gsr98]

This post is deleted!

[Bryce]

Looks nice harwood keep up the good work!