Manual Tranny Swap

[HandoEX]

Is the Exedy stage 1 organic clutch decent? Will it hold up spraying a 55-65 shot?
How about an 8lb Fidanza flywheel?

Any other suggestions for a clutch and flywheel in similar price ranges?

[24valvenotak]

car-part is probably the most consistantly inexpensive place to find parts

[weshole]

92BlackTT wrote:
car-part is probably the most consistantly inexpensive place to find parts

Ya, for used O.E.M. parts not aftermarket or performance parts.

[24valvenotak]

This post is deleted!

[24valvenotak]

^yea, junkyard parts that nobody on here seems to want to consider

[HandoEX]

Transmission from a 2000 Accord with 24k miles
ACT heavy duty clutch & flywheel
OEM slave cylinder, master cylinder, pedal assemblies, shifter assemblies, axle & half shaft, blah, blah, blah

Car is all done except reflashing the ecu for the Honda immobilizer, which will be done at Corwin tomorrow. I did drive it home tonight but the car is in limp mode...no vtec and fuel cut at 4700rpm.

Thanks to Nick and Tony at SLS for putting up with my constant phone calls about this shit over the last few weeks.

Last but not least, BIG thanks to Frank at SLS. Frank really knows his shit and really bent over backwards to get this done for me. I can't thank him enough for finishing my car under the circumstances.

[STiSchucky]

thanks to kirk for keeping tony company at corwin hondas incredibally slow custmer service desk

[PSiedTSi]

It certaintly was a long and tideous process to track down all those odd and end parts(and sometimes irritating trying to get the right parts coming), but it seemed to come together nicely right at the last!

You helped us out a lot by having your homework done on this and sourcing a lot of the parts. Thanks again Jason.

[Bryce]

Awsome Jason it looks so good!! I can't wait for a ride.

[treimche]

Good to see it all done man. Hopefully it will go a little faster now.