cage requirements???

[DrifterExtreme]

Well after turboing the coupe i have decided to go al out and build the car up a bit... So my question is were do i find out the requirements to run 11's or faster? also i need to know if certain things are needed to pass tech like a scatter sheild, or a oil pan dieper thing?... also what fuel system(ie: fuel pump, fuel filter, and lines) you guys running? any info would be great?

[MisterCMK]

You should look into getting an NHRA rulebook.

[Bryce]

Forget the cage you need vtec.

[MisterCMK]

vtec is lame

[KA-T_240]

MisterCMK wrote:
vtec is lame
quoted for the true. but i well make exceptions to this one

[DrifterExtreme]

well i might not have vtec.... but we will see

[Joel]

boosted b20 ftw!

[integra_gsr98]

11.49 or faster - 6 point roll bar required
mild steel can be mig welded, chromoly must be tig welded

scatter shield @ 11.49 or faster
fire jacket @ 11.49 or faster
extended wheel studs and open ended lug nuts @ 11.49 or faster
3" wide 5 point harness @ 11.49 or faster

i ran 11.2 on a walbro 255 hp and stock lines

[DrifterExtreme]

Thanks for the info nick. I'm shooting for low 10's if not faster... Hopefully with my new setup i will meet my goals...

[treimche]

Isn't it supposed to be an 8 pt roll bar?

[integra_gsr98]

Actually from looking at the rules only a 5 point is required at 11.49. However almost every entry level kit is an 8 point.

[MisterCMK]

Nick, do you know where one can dowload a copy of the NHRA rulebook?

[integra_gsr98]

Off of NHRA.com.

[MisterCMK]

Where? I didn't see it on there.

[integra_gsr98]

I couldn't find the link on there again, but here is the link for the Sport Compact rule book.

http://www.nhrasportcompact.com/2006/rules/index.html

[weshole]

DrifterExtreme wrote:
Thanks for the info nick. I'm shooting for low 10's if not faster... Hopefully with my new setup i will meet my goals...

Hey Matt, Exactly what set up are you planning on running anyway? Motor, Trans, Turbo, Tuning?

[Joel]

i'm guessing b20...

[DrifterExtreme]

^^^^your guessing wrong...as always...

motor:

• sleeved b16 bored to 83mm
• je pistons 9.1:1????
• pauter rods
• balenced crank
• b16 head ported/polished
• rocket springs/retainers
• custom intake manifold
• mustang TB

Trans:

• ls tranny
• 4.7 final drive( i think dunno yet)
• liberty gear cuff
• obx lsd (i want to see if this holds up)
• gearspeed syncros
• os giken twin plate unsprung

Turbo set up:

• GT40 (don't know specifics yet)
• custom manifold (equal length and pulse)
• 4" down pipe
• 4" AL exhaust
• huge fmic(thinking about air/water)
• fuel setup???
• aem???
• cop ignition
• cam trigger

Thats all i know for now

[integra_gsr98]

Looks like Honda-Tech mod list 101 except on a small bore short deck motor and an LS trans.

[DrifterExtreme]

I hope that wasn't your way of being clever....