My Improperly set welder...
-
Damn i was the only one said nice welds to joel and i STILL didnt get a thank you??? Well the hell with that...joel your welds suck ass!!! jk
"tell the misses that thats how you got the man and thats how you KEEP the man
words to live by from the wise one"
-weshole -
ok now to bring some drama back into this thread....
Zac, your tig welds suck balls.
:faq-roll:
-
Parker;212046 wrote:
prove itProve what, that there's ugly welds beneath that heat wrap? That's why we did it, hahaha. It was the only Pro Hot Rod car with heat wrap this weekend.
The manifold holds up fine, it just doesn't look the best, haha.
-Peter
1991 240SX
-
Here is my question. I know nothing about blonde asian women, baseball, or welding. Even though Joel's welding yields some jizzum splatter, does it effect the strength of the weld? For the flange on the downpipe, would a 'non jizzum splatter' weld offer the extra NEEDED strength, or would it be ok? I ask in all seriousness, cause besides not being the most attractive, I don't see why it wouldn't do the task... Again, I am a welding noob and have utmost respect to anyone that can make a straight bead.
-
^From my understanding, it is more that the machine was not set up properly for the welding that it was used for. The splatter is material that could have been part of the weld. For the exhaust welding, its not a problem, I have seen MUCH worse work from local exhuast shops.
-
KA-T_240;212192 wrote:
^From my understanding, it is more that the machine was not set up properly for the welding that it was used for. The splatter is material that could have been part of the weld. For the exhaust welding, its not a problem, I have seen MUCH worse work from local exhuast shops.It had to do with the fact that I had only 700 PSI of gas left, and I was at the end of a small spool of wire(meaning the wire comes out of the tip of the gun very unevenly.) Settings had nothing to do with it, otherwise the weld itseld would look like shit.
-
Joel;212205 wrote:
It had to do with the fact that I had only 700 PSI of gas left, .LOL are you serious???? really now are you serious??
drrrrrrrrrrrrrr hhmmmmm that flow meter next to the cylinder pressure gauge does nothing
a cylinder with with only 300psi left is going to hold a steady CFH of gas flow.... it will stay consistent and not fall off till it cannot the support the level of gas flow you are asking for........... which is far far south of 700psi
lol god that is fucking funny...... we change all our $70 worth of shielding gas out when it gets below 1000psi because it makes my welds look like dog shit
I thought you go to NDSU........... pay more attention in the fluid/gas dynamics section of your physics class
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login