Guage install help.
-
-
im just goin to have all the front end parts off to perform the wiretuck and im installing the exhaust at the same time seeing how i will have the O2 sensor unpluged i can take it off the stock mani and install it on the header. Im going to do it all at once is what i am saying.
-
just search on google then you will find tutorials for all of them they are all pretty easy.
-
harwood39 wrote:
Ok, here is the deal. I need to know how to install the following Guages into my civic.Air/Fuel
Oil Preasure
Water Temp
Volt meterI am picking them up used so i dont have directions.
the a/f is usually connected to the ecu. search on the internet
idk if the oil pressure guage is electrical or mecanical. if its electrical connect it to the oil pressure switch on the oil filter housing. if its mecanical, there is a threaded plug on your oil filter housing. Take that out and put a barbed fitting in there and connect a hose from that to the guage.
the water temp guage should come with a sensor. your car should have a stock water temp sensor. Take the stock one out and put the one in that comes with the guage, and run a wire from the sensor to the guage.
The volt meter is pretty easy. There are three wires coming out of the guage. one is ground the other two are constant power and switched power. idk which ones are which, but one goes to the battery one goes to a switched circuit that makes the guage shut off with the ignition.
I have all these guages in my car and I installed them myself, so if you need some more details let me know
-
they look a whole hell of a lot bettter than stock thats why....
-
out there wrote:
air/fuel - why do you need a blinky light show?
oil pressue - good idea
water temp - stock isn't good enough?
volt meter - why?
not trying to tell you to avoid gauges completely... but there are some that just aren't necessary
He plans on putting a turbo in his civic, so the a/f might be worth it. Volt meter is just for looks. -
Ok, this is what i found out on ht.
Air/Fuel ---> Black wire: Any ground Red Wire: Thick red wire or thick black with yellow stripe on 3 prong conector for ignition Purple: Thick solid white wire on the middle conector of the ecu.
Oil Preasure ---> Tap into the existing harness and black and red are the same.
Water Temp ---> Tap into existing harness and black and red are the same
Volt ---> black wire: neg on battery, red to ignition.
-
do not wire it ghetto....mine was wired ghetto and everything was fucked up.........starts fires right jim!
-
I know about starting your dash on fire. Its not cool.
I ghetto wired all of my street glow, my neons and shit back in the day and as I drove to the twin citeis the shit started on fire, iw as like OMG and i pulled off, and had to un hook everything. Not a big fire, but there was smoke, and the speaker wire i twisted togther was shot.
Just a headsup harwood.
-
only you would do that jim!
-
i know i was just joking around.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login