Exhaust

[KA-T_240]

Joel, your going to help me make the exhuast on the black car right?

And I can sell you all be bends, piping, and muffler stuff.

[Joel]

JN210;209887 wrote:
How much would that be for you to make one?, I may wait for the turbo so it all gets done at once. I want some prices so I know how much to save up for.

totally depends on what kind of exhaust you want... piping plus 40 bucks per hour(Labor, wire and gas costs), will take me less than 2 hours for sure...

[Parker]

[Joel]

wtf?

[DelSlow]

This post is deleted!

[zbrown]

lol, not you joel

[JN210]

Parker;209891 wrote:

uhh.....ok?

So about close to 100 - 150 then for a good exhaust i assume?

[KA-T_240]

^NO

You still will need: pipes, bends, muffler, cat

[JN210]

I should have a significant amount this summer (this problem came to my attention this afternoon as I watched exhaust billow out from under my car) I was thinking 2.5in piping and a 3in tip perhaps?.....or I could go dual outlets...idk, then I would have to have another exhaust head and all made and that would be expensive.....

[KA-T_240]

dual FTL

[z31]

Just go ahead and make the exhaust 4 inch. Your going to need it with 180 Crank Horse Power. :3gears:

[Slow97Camaro]

whats a cat?? hah thats just more restrictions and more cost. just go with 3" all the way and you'll be happy.

[SPANISH-RICE]

just 3" it off the bat

[zbrown]

anything less than 4" is weak

[Parker]

agreed

[capitlj]

Duals FTMFW, symmetry is beauty Faber

[Krazy_Kling]

when my Z comes in i want to pick up a good quality brand of exhaust, the one brand that interests me the most is the HKS Hi-Power exhaust but i wish it was a little more affordable. Any suggestions?

[JN210]

Krazy_Kling;209990 wrote:
when my Z comes in i want to pick up a good quality brand of exhaust, the one brand that interests me the most is the HKS Hi-Power exhaust but i wish it was a little more affordable. Any suggestions?

Isnt this my thread?....make your own buddy. would 3in piping and 4in tip be wise?....combine the two.

[inspector01]

JN210;210017 wrote:
Isnt this my thread?....make your own buddy. would 3in piping and 4in tip be wise?....combine the two.

That is the same as 3 inch, it can only flow as much as the smallest part allows, you could have a 40" tip and still flow like your 3 inch piping.

[Grr]

or you could just buy the one jason is taking off his car, everyone that has heard it thinks it sounds fuckin wicked, then theres no work involved.