My project
-
It's a gt-45 ( 70mm ) if i remember. It was free i'm planning on upgrading after it get this set-up done. I started looking at an S400 75mm with a T-4 flange. But i'm open to suggestion's
-
I really don't know if I will have the room for a T6 unless i cut into the fender well but then i might not have room around the hood. It's kinda tight around the turbo right now plus i will not have room for the down pipe. We were able to get 3.5 inch to fit right and i really don't want to cut into the frame that much. I even think 4 inch would be tough to do.
-
well not much progress as of late. just a lot of ordering of parts. but i can say christmas is going to come early this year as everything i ordered should be here by next tuesday. then next week while i'm on vacation i will work on the fuel system and possibly pull the motor out and swap out the oil pan and weld in the drain for the turbo. i also might start some of the wiring
-
Well christmas came early for me (transmission, most of my fuel system part's, starter, and misc part's i ordered). plus my buddy got his converter back and his engine for his race car. so it has been a good week for both of us
-
Fuel system is almost done just have the cross over left to do. Will get that done tomorrow and then pull the motor out and swap out oil pan's and work on the oil drain for the turbo. Than after my torque converter show's up put it all back together and figure out radiator hose's and heater hose's
-
Ok here is an update with some picture's. Transmisson is a th-350 with a b&m stall
-
well it's been a while since an update. computer wiring done under the hood and radiator ordered and modifed
-
Well it's almost done. just waiting on b.o.v. got it running last week.
[legacy attachment 6929]
-
Got my b.o.v. today. But i was able to drive it before i got home and saw that it showed up. Car run's really good considering it's not tuned at all. I also have traction issue's as soon as it start's to boost the tire's break loose.
-
I have been out driving it. Now to finish the exhaust and install the part of the cage
[legacy attachment 6934]
[legacy attachment 6935]
-
I really have no idea on how much power it is making yet. Only seeing about 5-6 psi right now. Yes my name is Doug
-
Almost done with the exhaust. 3.5in all the way back.
-
Well i guess i should give you all an update. Started tuning the car under boost and damaged the rear-end ( in the words of my buddy "it was whining like an un-paid hooker" ) So i ordered a ford 9 from moser and got an upgraded drive shaft.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login