WTB: Injector box and map sensor

[inspector01]

Go to radioshack and ask for 4 10ohm, 10watt resistors, and wire them inline. Very simple and costs about $4.

[SPANISH-RICE]

very true and you can hid them up by where you would install the resistor box still for a clean install.

[gsrEK]

SPANISH-RICE;223812 wrote:
very true and you can hid them up by where you would install the resistor box still for a clean install.

WORD thanks again

[SPANISH-RICE]

lawlski

[BlackEJ8]

what should i do about the clips?

[SPANISH-RICE]

i can show you how to modify them but its really easy. just cut off a tab on your factory clips and they will work with like any injector

[inspector01]

I do the inline resistors under the intake manifold so they can't be seen. And for injectors, i always just take a utility knife and cut out the one little tab on the inside part of where the clip goes and cut that off, then stock clips slip right on.

[SPANISH-RICE]

exactly^

[BlackEJ8]

thanks guys!!

[SPANISH-RICE]

yup.. when you say its finally boosted... youre not driving it on the factory injectors/tune are you???

[BlackEJ8]

Haha actually I have driven it, but not going over 2500 and also there is a section of IC piping out to make sure it doesnt create boost.

[SPANISH-RICE]

alrighty. just make sure