Z31 Introduction

[z31]

This is the difference between the stock down pipe VS the CM 3 inch in the area that goes under the transmission cross member. :icon_geek:

[z31]

9:1 Pistons and rods in assembled short block.

[Grr]

bout time you get something done

[zbrown]

So why didn't you stick good rods and pistons in? or are stock pistons forged?

[zbrown]

$500 forged pistons >>> $500 exhaust

[z31]

zbrown;269588 wrote:
$500 forged pistons >>> $500 exhaust

$575 Exhaust as A mater of fact. :icon_bigsmurf:

[z31]

zbrown;269585 wrote:
So why didn't you stick good rods and pistons in? or are stock pistons forged?

The stock NA internals have been run at 500 WHP by quite a few people.

[zbrown]

z31;269625 wrote:
The stock NA internals have been run at 500 WHP by quite a few people.

then why does it seem like there is a rotary engine under your hood??

[z31]

zbrown;269630 wrote:
then why does it seem like there is a rotary engine under your hood??

Explain? :icon_scratch:

[Grr]

it comes out at least once a year to be rebuilt, much like a rotary

[24valvenotak]

it might not be fast and it might not handle that well but it aint a pimp whip if the lights dont flip.

[z31]

Grr;269647 wrote:
it comes out at least once a year to be rebuilt, much like a rotary

What are you talking about? I haven't rebuilt any motors VG30 motors, and the one I'm currently working on is only half done. So does that count as .5 VG30 motors? :icon_scratch:

[fdfreak]

how is it going Jason? welcome? i dont know im confused. too many people introducing themselves after they have been on here for 2+years. I might just have to introduce myself again just to start a new thread.

anyway, hope to see you out a little more this summer. you and Gary both. Maybe I go to the wrong events.

[zbrown]

z31;269739 wrote:
What are you talking about? I haven't rebuilt any motors VG30 motors, and the one I'm currently working on is only half done. So does that count as .5 VG30 motors? :icon_scratch:

ok so you haven't rebuilt one yet...... you instead just go buy another stock salvage engine

[Grr]

whats wrong with that? you did it!

[z31]

zbrown;269750 wrote:
ok so you haven't rebuilt one yet...... you instead just go buy another stock salvage engine

$100 engine here, $100 engine there, here an engine, there an engine.......:icon_geek:

[zbrown]

Grr;269751 wrote:
whats wrong with that? you did it!

True..... trying to take steps so that is a thing of the past.......... hopefully

[Grr]

arent we all?

[zbrown]

Grr;269877 wrote:
arent we all?

doesn't seem like the OP is.....

[z31]

zbrown;269874 wrote:
True..... trying to take steps so that is a thing of the past.......... hopefully

Same here. But Zac, you Know we end up pushing them till they break. :icon_bigsmurf: